7. Enter ag --modeshow, and then press Enter key. Confirm the message
and identify the switch operation mode.
Message Switch operation mode
Access Gateway mode is NOT enabled Native
Access Gateway mode is enabled Access Gateway
8. Skip this step when the switch is 8Gb FC switch module.
Enter mapspolicy --show -summary, and then press Enter key. Confirm
the message and identify the switch monitor mode.
Message Switch monitor mode
MAPS is not enabled yet. Fabric Watch
Active Policy is 'xxxx_policy' Access Gateway
9. Skip this step when the switch is 8Gb FC switch module or monitor mode
is Fabric Watch.
Enter mapsconfig --show, and then press Enter key. Confirm the
message in Configured Notification line and identify the MAPS action
settings.
The MAPS action settings are RASLOG, SNMP, SW_CRITICAL,
SW_MARGINAL, and SFP_MARGINAL, at the maximum.
4-26
Common process for replacement
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
