Installing the equipment in a rack
To install or remove the system equipment in or from the rack cabinet,
always get help from at least one other person or use tools. If the system
equipment has to be installed on 31U and above of the rack cabinet or it
is already installed there, call for maintenance personnel instead of
attempting to install or remove it. Defective installation may cause the
system equipment to fall, resulting in injury or equipment failure.
Requirements for the product
Install the product on a fixed rack. Do not lean against the product or
stand on it. Do not install the product in a place with weak floors and
walls.
Do not subject the product to excessive vibration. That can drop and fall
the product, leading to failure.
Using a rack cabinet
When using a rack cabinet, do not place anything on the system unit
mounted on the cabinet and do not use the top of the system unit
mounted on the cabinet as a workbench. A heavy object placed on top of
the system unit on the cabinet may fall, resulting in injury.
Locking the rail into place
Be sure to pull out the equipment until it locks into place. If not, the
equipment may move unexpectedly, which causes you to get injured such
as your finger caught in the gap.
Improper battery type
Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of
Used Batteries According to the Instructions.
Handling of batteries
Since maintenance personnel should change batteries, do not change
them yourself. Follow the instructions described below. Inappropriate
xvi
Preface
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
