Figure 5-13 Removing the pass through mezzanine component
5. Grab the pass through mezzanine card shown as arrows A and B, then lift
up the pass through mezzanine card and remove it from the server blade
and storage expansion blade assembly.
Figure 5-14 Removing the pass through mezzanine component
6. Lift up the server blade side. The tilt angle would be less than 45 degree.
7. The following figure shows the bottom side of the storage expansion
blade. Pull the latch against bottom plate with your finger to release the
latch.
8. While releasing the latch in the center of the bottom plate, slide out the
server blade.
5-18
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
