3. Open a latch of the connector of the connection kit F/H in the PCI
expansion blade, and then pull out the connector straight upward.
See Figure 5-22 Removing the connection kit F/H on page 5-23.
4. Open two latches of the connection board in the server blade, and then
pull out the board straight upward.
See
Figure 5-22 Removing the connection kit F/H on page 5-23.
5. (Skip this step when the connection kit L/P is not installed.)
Pull out the connector of the connection kit L/P in the PCI expansion blade
straight upward, and then turn over the connector toward server blade.
See
Figure 5-23 Removing the connection kit L/P on page 5-23.
6. Loosen a thumbscrew of the connection bracket, and then remove the
bracket. See Figure 5-24 Removing the connection bracket on page
5-24.
7. (Skip this step when the connection kit L/P is not installed.)
Pull out the connection board of the connection kit L/P in the server blade
straight upward. See Figure 5-25 Removing the connection kit L/P on
page 5-24.
Figure 5-21 Location of the connection kit
5-22
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
