4. When the SAS kit 2 is mounted in the CB 540A A1/B1, remove the SAS
kit 2 from the server blade. See Removing a SAS-kit 2 on page 5-93
section.
(Skip this step to remove a DIMM in CB 520X B1/B2/B3.)
5. Lift the air ducts, and remove them from the server blade assembly.
Figure 5-56 Removing the air ducts- CB 540A A1/B1
Figure 5-57 Removing the air ducts- CB 520X B1/B2/B3
6. Open the DIMM socket ejector tabs and remove the DIMM from the DIMM
socket.
5-46
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
