4. Select TCP/IP (Winsock), enter <IP address> in the Host address,
and then click OK.
< IP address >:IP address for the target switch module. See
Internal IP
address setup procedure for switch module on page 4-18 section.
5. The login prompt is displayed in the terminal.
Figure 5-149 Connecting to 8Gb/16Gb FC switch module
6. Enter admin as login name, and then press Enter key.
7. Enter password as password, and then press Enter key.
8. Confirm that the command prompt is indicated.
To check the SFP function for 8Gb/16Gb FC switch module;
1. Enter sfpshow, and then press Enter key.
Replacing parts
5-117
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
