The following procedure varies depending on BIOS version.
For BIOS version 2.02a1, perform the following procedure.
For BIOS version 2.12a13, skip to
Restoring parameter of FC mezzanine
card when BIOS version is 2.12a13 on page 7-23.
7. The BIOS utility is displayed. Enter < number > and then press Enter
key.
< number > : 1 or 3 the first port number of the replaced card
8. Confirm and record Port Name and Node name.
9. Enter 2, and then press Enter key to confirm registered boot device.
10. The parameter List is displayed.
11. Enter < number > from 1 to 11 respectively to set up each parameter,
and then press Enter key.
Configuring Emulex mezzanine card
7-19
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
