Hitachi CB 520H A1 Service Manual

6 Identifying RAID rebuild status ........................................................... 6-1
Identifying rebuild status ..................................................................................... 6-2
In hot-swap (Internal Storage Monitor) ................................................................. 6-2
Windows environment ................................................................................... 6-2
Linux environment ......................................................................................... 6-7
7 Configuring Emulex mezzanine card .................................................... 7-1
Configuration procedure for Emulex HBA card ....................................................... 7-2
8 Gb FC 2-ports mezzanine card ........................................................................... 7-3
Confirming the parameters of 8 Gb FC mezzanine card .................................... 7-3
Restoring the parameters of 8 Gb FC mezzanine card ..................................... 7-18
16 Gb FC 2-ports mezzanine card ........................................................................ 7-38
Confirming the parameters of 16 Gb FC mezzanine card ................................. 7-38
Restoring the parameters of 16 Gb FC mezzanine card ................................... 7-44
10Gb CNA 4-port mezzanine card ........................................................................ 7-54
Confirming the firmware versions ................................................................. 7-54
Confirming the iSCSI settings ....................................................................... 7-57
Confirming the UMC and Personality settings ................................................. 7-63
Preparing to confirm the FCoE settings .......................................................... 7-64
Confirming the FCoE settings ........................................................................ 7-65
Updating the firmware of Emulex CNA/LAN mezzanine card ............................ 7-71
Reconfirming the server model and firmware versions .................................... 7-80
Restoring the iSCSI settings ......................................................................... 7-81
Restoring the UMC and Personality settings ................................................... 7-90
Rebooting the server before restoring FCoE settings ...................................... 7-94
Restoring FCoE settings ............................................................................... 7-95
Restoring backed up CNA information ......................................................... 7-104
8 Diagnosing server blade ..................................................................... 8-1
Diagnostic procedure overview ............................................................................. 8-2
Connecting the remote console ............................................................................. 8-2
Starting remote console by using server blade Web console. ............................ 8-5
Starting Compute blade test program (CBTP) ........................................................ 8-6
Diagnosing the server blade ............................................................................... 8-10
Set server blade power value ....................................................................... 8-10
Verifying the hardware configuration ............................................................ 8-11
Executing CBTP ........................................................................................... 8-13
Closing the test program .................................................................................... 8-14
9 Updating firmware ............................................................................. 9-1
Updating BMC/EFI firmware on server blade .......................................................... 9-2
Updating firmware on management module .......................................................... 9-3
Updating firmware on switch module .................................................................... 9-5
1Gb LAN switch module or 1/10Gb LAN switch module .................................... 9-5
8Gb / 16Gb FC switch module ........................................................................ 9-8
10Gb DCB switch module ............................................................................. 9-12
10 Change LOM configuration ............................................................. 10-1
Overviews of changing LOM configuration ........................................................... 10-2
ix
Hitachi Compute Blade 500 Series System Service Manual

Hitachi CB 520H A1 Specifications

General

Brand	Hitachi
Model	CB 520H A1
Category	Server
Language	English