Hitachi Compute Blade 500 Series - Page 174

8. Select the added device in USB tab, click Add to boot order.
When the necessary device is not displayed, to be recognized the
necessary device as follow the procedure of Connecting to virtual drive on
page 2-153.
Tip: [Management module firmware version A0205 or later]
When multiple USB ports are assigned to an LPAR, a single port is
displayed.
9. Select the added device in HBA tab, click Add to boot order.
When the necessary device is not displayed, to be recognized the
necessary device as follow the procedure of HBA boot driver settings.
2-150
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide