Hitachi Compute Blade 500 Series - Page 292

Table 2-147 Operation result
Operation result Descriptions
Success indicates Success of operation
Failure indicates Failure of operation
Occurrence indicates Occurrence operation
(The result is not categorized to Success or Failure.)
The following table shows the audit log format. The format is the same for
management modules and for server blades.
Table 2-148 Format of the audit log
Item Descriptions Remarks
Common identifier
(CommonSpecID)
Fixed to CELFSS
Common specifications
revision number
(Rev)
2
Sequence number
(seq_no)
ID number to identify the log order.
Assigned 1 to 9999999999.
Return to one when exceed
9999999999.
This corresponds to
the seq_no item of
the operation log.
Message ID
(msgid)
The message ID (hexadecimal). This corresponds to
the msgid item of the
operation log.
Date & time
(date)
Date, time, and time zone when
recorded the operation.
YYYY-MM-DDThh;mm:ss.SSS+h2:s2
YYYY: year, MM: Month, DD: Date,
T: fixed (delimiter), hh: hour, mm:
minute, ss: second
SSS: mili-second (fixed to 000),
h2: Time zone offset hour, s2: Time
zone offset minute
This corresponds to
the date item of the
operation log.
Detection entity
(EntityInfo)
The operated equipment name.
Management module operation log:
Management module
Detection location
(Location)
The operated host name.
Management module operation log: IP
address for management module
This corresponds to
the place item of the
operation log.
Operation category
(Category)
The category name categorized by
operation type.
Corresponds to categ
in the operation log.
2-268
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide