Hitachi Compute Blade 500 Series - Page 298

ID
Operation
category
Recording trigger Message
3863 Changing server blade
settings.
On Server blade N, setting is
changed. Channel:xxx Category:xxx
3864 Changing management
LAN settings for server
blade.
On Server blade N, LAN setting is
changed. Channel:xxx Category:xxx
Value:xxx
3867 Changing Optional
Physical WWN settings.
Additional WWN is changed.
Channel:xxx Server blade:xxx
3868 Changing Optional
Physical WWN settings.
Additional WWN is changed.
Channel:xxx Server blade:xxx
Card:xxx Slotxxx
3869 Initializing Optional
Physical WWN settings.
Additional WWN is initialized.
Channel:xxx Server blade:xxx
386A Initializing Optional
Physical WWN settings.
Additional WWN is initialized.
Channel:xxx Server blade:xxx
Card:xxx Slotxxx
386B Changing Optional
Physical MAC settings.
Additional MAC is changed.
Channel:xxx Server blade:xxx
386C Changing Optional
Physical MAC settings.
Additional MAC is changed.
Channel:xxx Server blade:xxx
Card:xxx Slotxxx
386D Initializing Optional
Physical MAC settings.
Additional MAC is initialized.
Channel:xxx Server blade:xxx
386E Initializing Optional
Physical MAC settings.
Additional MAC is initialized.
Channel:xxx Server blade:xxx
Card:xxx Slotxxx
3870 Request of restoring to
default settings for
server blade.
Reset Server blade N to factory
default setting. Channel:xxx
Category:xxx
3872 Sending test alert for N
+M cold standby.
On Server blade N, JP1/SC/BSM
send test alert (N+M cold standby)
Channel:xxx Category:xxx
3873 Backing up sever blade
settings.
On Server blade N, setting (xxx) is
backed up. Channel:xxx Bkup
time:xxx File:xxx
3874 Restoring sever blade
settings.
On Server blade N, setting (xxx) is
restored. Channel:xxx Bkup
time:xxx
3875 Removing backup file
for sever blade settings.
On Server blade N, setting (xxx) is
removed. Channel:xxx
3876 Backing up sever blade
settings.
On Server blade N, setting (xxx) is
backed up. Channel:xxx
Category:xxx Slot:xxx Bkup
time:xxx File:xxx
2-274
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide