Hitachi Compute Blade 500 Series - Page 310

Tip: When updating the management module firmware, execute step 3.
3. Check Hot standby status both management modules 0 and 1.
Tip: Use the result of step 3 to check status after updating.
4. Click Management Modules > management module x with Active
for
Hot standby status from the tree on the left.
5. Condition tab shows the current Management module firmware version,
Dictionary version, and Equipment parameter version. Check that the
latest versions, which are obtained in (1) Obtaining the latest versions of
Management module firmware/Dictionary/Equipment parameter, are later
than the current versions.
2-286
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide