ID Level Message
Description
This message may be appeared several times depending on the maintenance type.
[Action] No particular action required.
FF22 FAIL On <X>, a failure occurred in <Y>
during smart configure.
[Meaning] In the server blade at the part shown in X, a failure occurred during a Smart
Configure process in the component indicated by Y.
[Action] Contact your sales or service representative.
FF23 WARNING On <X>, an invalid setting was found in
<Y> during smart configure.
[Meaning] A Smart Configure process in the server blade at the part shown in X, failed
because the component indicated by Y was set up incorrectly.
[Action] Y is an HBA slot number or a port number. Review and amend the HBA BIOS
settings for the specified slot, and then manually run the Smart Configure process. If the
same message appears again, contact your sales or service representative.
FF24 FAIL On <X>, a smart configure error was
detected.
[Meaning] A failure was detected in a Smart Configure process running on the server
blade at the part shown in X.
[Action] Contact your sales or service representative.
FF25 WARNING On <X>, an error occurred when smart
configure was being performed.
[Meaning] An error occurred during execution of a Smart Configure process on the
server blade at the part shown in X.
[Action] Contact your sales or service representative.
FF28 Info On <X>, error alert (immediate
replacement) is sent by the user request
operation.
[Meaning] A test of the N+M cold standby function (immediate failover) was performed
on the partition indicated by X.
[Action] No particular action is required as the message relates to a test.
FF29 Info On <X>, error alert is sent by the user
request operation.
[Meaning] A test of the N+M cold standby function (other than immediate failover) was
performed on the partition indicated by X.
[Action] No particular action is required as the message relates to a test.
FF2A FAIL On <X>, a failure requiring an
immediate failover occurred.
[Meaning] A failure which is subject to immediate failover by the N+M cold standby
function occurred on the server blade indicated by X. The affected server blade will now
fail over to its counterpart in the standby system.
[Action] Contact your sales or service representative.
A-12
HCSM alert log message
Hitachi Compute Blade 500 Series Management Module Setup Guide
To Next Page
Loading...
