Hitachi Compute Blade 500 Series - Page 357

ID Level Message
Description
FF2B FAIL On <X>, a failure requiring a failover
occurred.
[Meaning] A failure which is subject to delayed failover by the N+M cold standby function
occurred on the server blade indicated by X. The affected server blade will now fail over
to its counterpart in the standby system.
[Action] Contact your sales or service representative.
FF40 Warning The scheduling mode for a NIC assigned
to an LPAR was changed.(Location:<X>,
Event:<Y>)
[Meaning] The scheduling mode of a NIC allocated to an LPAR was changed.
<X> indicates the location, and <Y> indicates the event that occurred.
[Action] LPAR manager has shifted to the safe mode. Confirm the NIC allocation to
LPARs, change the setting of allocation to LPARs if required, and then release the safe
mode.
FF41 FAIL An failure event on a management NIC
was detected.(Location:<X>,
Event:<Y>)
[Meaning] An failure event was detected on the specified management NIC.
<X> indicates the location, and <Y> indicates the event that occurred.
[Action] If the location is "-", no action is required.
If the location is other than "-", do the following:
(1) Confirm that the specified management NIC is correct.
(2) If no problem is found in (1), confirm whether a NIC that supports the shared mode
is installed on the indicated location.
FF42 Warning A warning event on a management NIC
was detected.(Location:<X>,
Event:<Y>)
[Meaning] A warning event was detected on the specified management NIC.
<X> indicates the location, and <Y> indicates the event that occurred.
[Action] If the location is "-", no action is required.
If the location is other than "-", do the following:
(1) Confirm that the specified management NIC is correct.
(2) If no problem is found in (1), confirm whether a NIC that supports the shared mode
is installed on the indicated location.
FF43 Information LP started, with the specified ports set as
the LP management NIC ports.
(Location:<X>)
[Meaning] LPAR manager started on the LPAR manager management NIC specified by
the user.
<X> indicates the location.
[Action] None.
HCSM alert log message
A-13
Hitachi Compute Blade 500 Series Management Module Setup Guide