Hitachi PB - Page 92

5-4
Appendix: nozzle drive conditions
This table shows the nozzle drive conditions for each ink of the PX type IJP together.
When performing the reset or the like of the kinds of ink, be careful because the excitation
frequency and the standard pressure vary depending on the ink.
(1) 65 mm nozzle
Standard pressure
Ink
（MPa）
Excitation
frequency
（ｋHz)
Temperature
range
（℃）
Remarks
K26 0.255 68.9
0〜35
K27 0.255 68.9
0〜45
R27 0.255 68.9
0〜35
B27 0.255 68.9
0〜35
G27 0.245 68.9
0〜35
K28 0.245 68.9
0〜35
K31A 0.245 68.9
0〜35
K33 0.255 74.0
0〜35
K60 0.245 68.9
0〜35
K61 0.245 68.9
0〜35
K62 0.255 68.9
0〜35
F63 0.255 68.9
0〜35
T64 0.255 68.9
0〜35
K65 0.255 68.9
0〜35
K67 0.255 68.9
0〜45
K68 0.245 68.9
0〜35
R65 0.255 68.9
0〜35
K69 0.255 68.9
0〜45
K70 0.255 68.9
0〜35
T71 0.255 68.9
0〜35
K72 0.255 68.9
0〜40