5-6
(6) Perform the assembly in inverse procedure.
Caution
①When mounting the rear cover and the deflection base, pay attention to
pinching of the lead and gasket.
②
There are two kinds of length of the M2 screw. It may cause a failure
if mistakenly mounted
.
(7)
Coat the high-voltage electrical power lines setscrew part with silicon rubber
according to the following procedure.
①Fill the top and bottom of the ring terminal with silicon rubber, using a dispenser.
Caution
a) Hold the head as shown below in order to prevent the silicone from
running.
Nozzle
High-voltage line terminal
(round terminal)
Dispenser
Insert the tip of the dispenser
into the downside of the
terminal to fill the downside
space.
High-voltage line terminal
(round terminal)
Dispenser
If the downside is
almost filled, fill up the
upside of the screw.
To Next Page
Loading...
