Honeywell
Warnings and Cautions
Warnings
Fire Safety and Liability Notice: Never connect card readers to any critical entry, exit door,
barrier, elevator or gate without providing an alternative exit in accordance with all fire and
life safety codes pertinent to the installation. These fire and safety codes vary from city to
city and you must get approval from local fire officials whenever using an electronic product
to control a door or other barrier. Use of egress buttons, for example, may be illegal in
some cities. In most applications, single action exit without prior knowledge of what to do is
a life safety requirement. Always make certain that any required approvals are obtained in
writing. Verbal approvals are not valid.
Honeywell never recommends using WIN-PAK or related products for use as a primary
warning or monitoring system. Primary warning or monitoring systems should always meet
local fire and safety code requirements. The installer must also test the system on a regular
basis by instructing the end user in appropriate daily testing procedures. Failure to test a
system regularly could make installer liable for damages to the end user if a problem
occurs.
Earth ground all enclosures for proper installation.
Use suppressors on all door locks. Use S-4 suppressors for installation. Honeywell Access
Systems (HAS) recommends only DC locks.
Personal injury or death could occur, and the equipment could be damaged beyond repair,
if this precaution is not observed!
• Before installation, turn off the external circuit breaker which supplies power to the
system, including door locks.
• Before connecting the device to the power supply, verify that the output voltage is
within specifications of the power supply.
• Do not apply power to the system until after the installation has been completed.
Cautions
If any damage to the shipment is noticed, a claim must be filed with the commercial carrier
responsible.
Electro-static discharge (ESD) can damage CMOS integrated circuits and modules. To
prevent damage always follow these procedures:
• Use static shield packaging and containers to transport all electronic components,
including completed reader assemblies.
• Handle all ESD sensitive components at an approved static controlled workstation.
These workstations consist of a desk mat, floor mat and an ESD wrist strap.
Workstations are available from various vendors.
i
To Next Page
Loading...
Need help?
General
