Honeywell MX8000 - Edit Line - MX8000-LC1 (1 Line); Table 5-16: MX8000-LC1 Edit Line List Items and Description

MX8000 Installation and Operation Guide
5–56
How to Set Monitor Station
1. Follow the procedures in Section 5.5.2.7.
2. Press
.
The display Flashes on the Mon= field.
3. Press the or button to change the option from Yes to No or vice versa.
4. When the desired setting is flashing press
ENTER
MENU
.
5. To exit press
.
5.5.4 Edit Line – MX8000–LC1 (1 Line)
To edit an existing Line Device, follow these steps:
1. Log on to the receiver. (See Section 4.4.4 for log on procedure.)
2. Press
ENTER
MENU
button.
3. Press
7
for program menu.
The display will briefly display
Initializing
Please wait . . .
4. Press
2
to choose Line Device menu.
5. Press
3
to select MX8000–LC1 (1 Line)
6. Press
2
to edit Line.
The display will show a list of the existing Lines.
7. Press the
or arrow buttons to move through the available list.
8. When the equal sign is on the Line you wish to edit:
Press
ENTER
MENU
. The display will show a list of choices. Table 5–16 lists these choices and provides a brief
description.
Table 5–16: MX8000–LC1 Edit Line List Items and Description
Edit Line List Description
1 Handshake Seq This function is used to program the handshake order and
parameters for this Line.
2 Pulse Format Used to set the 5- and 6-digit format, Interdigit timeout,
acknowledgement, and to select if partially extended is enabled.
3 Line Options Used to set number of rings, ring on/off duration, threshold voltage,
and sample time.
4 Listen In Used to program the parameters for the listen in (two-way voice
communication) feature if used. Must not be used in UL installations.
5 Misc. Line Opt. Used to program hunt group number, enable or disable echo
suppression, and billing delay.
6 Ademco Auto Opt Used to select the BFSK auto output, 3/1 restore output, pulse
output, and FBII output.