Honeywell MX8000 - Copy Device(S)

MX8000 Installation and Operation Guide
5–68
4. Press the
or button to change the option from S/Fast to LAR300 or vice versa.
5. When the desired setting is flashing press
ENTER
MENU
.
6. To exit press
.
How to Set Pulse Extended
1. Follow the procedures in Section 5.5.2.
2. Press
6
for Ademco Auto Opt. menu (see Figure 5–29).
3. Press
.
The display Flashes on the Pls= field.
4. Press the or button to change the option from Extended to Not Extended or vice versa.
5. When the desired setting is flashing press
ENTER
MENU
.
6. To exit press
.
How to Set Extended Output
Note: This field will only be active when the Pulse Extended option above has been set to Extended.
1. Follow the procedures in Section 5.5.2.
2. Press
6
for Ademco Auto Opt. menu (see Figure 5–29).
3. Press
.
The display Flashes on the ExtOut= field.
4. Press the or button to change the option from High Speed to 4/2 or vice versa.
5. When the desired setting is flashing press
ENTER
MENU
.
6. To exit press
.
5.5.5 Copy Device(s)
Copy Device(s) allows you to either program a line to defaults or copy the programming of an existing line.
5.5.5.1 To Program the Default Settings Into a Device
1. Enter Program Mode (see section 5.1).
2. Press
2
for Line Device menu.
3. Press
1
(MX8000–LC3),
2
(MX8000–LRR), or
3
(MX8000–LC1) to select your line card type.
4. Press
3
for copy Line Device menu.