Honeywell MX8000 - Log on; Log off; Installer Profile; Operator Profile; Default User Codes

Section 4 – Operation
4–5
4.4 Log On / Log Off
Persons operating the MX8000 must log on and off the system. This is a way of keeping track of who is
operating the system at any given time. You can program a total of 40 codes. Each code will be assigned to
one of two user profiles (Installer profile or Operator profile). (See Section 4.4.3 for default user codes.)
4.4.1 Installer Profile
The Installer profile will have access to all options on the main menu (see Table 4–4 for “Main Menu”
options).
4.4.2 Operator Profile
The Operator profile has access to fewer main menu options than the Installer profile (see Table 4–4). These
options allow the operator to perform basic operation of the MX8000. Both profiles can acknowledge all calls
and events.
Table 4–4: Main Menu Option Items by Profile
Installer
Profile
Operator
Profile
Menu Options
✔ ✔
Call History
✔ ✔
System History
✔ ✔
System Info
✔ ✔
Set Time & Date
✔ ✔
System Restart
✔
Printer Menu
✔
Program Menu
✔
Diagnostics
Note: See Section 4.6 for detailed information on the main menu options.
You must have at least one Installer Profile Code programmed in the system at all times.
4.4.3 Default User Codes
At initial power up, the system provides two default user codes. User code 1 defaults with an Installer profile
and user code 2 defaults with an Operator profile. Table 4–5 shows the default codes and their profiles.
Table 4–5: Default User Codes
User Number
Default Code
(PIN)
Default Profile
*1 8000 Installer
2 1111 Operator
*Note: User code 1 can be changed but not deleted. User code 1’s profile will always remain as “installer”.
4.4.4 How to log on the system.
Follows these steps to properly log on to the system:
1. Press the
LOG
STATUS
button.
The VFD will display
Enter Log In Code:
[ ]
2. Enter your PIN code. (See Table 4–5 for default codes.)
Note: This screen will time out after 15 seconds.