Honeywell MX8000 - Page 4

iv
8.4.3
System Message Block.......................................................................................................................................8–7
8.4.4 Heart Beat Message Block .................................................................................................................................8–8
8.4.5 Validation Byte (V-Byte) ......................................................................................................................................8–9
8.4.6 ACKing and NACKing Data ................................................................................................................................8–9
8.4.7 Commands Initiated by the Automation Computer .........................................................................................8–9
8.5 ADEMCO 685 Automation Protocol ................................................................................................................8–13
8.5.1 Low Speed 3x1, 4x1, and 4x1 Express Automation Protocols....................................................................8–13
8.5.2 Low Speed 4x2 and 4x2 Express Automation Protocols .............................................................................8–13
8.5.3 ADEMCO High Speed Automation Protocols ................................................................................................8–13
8.5.4 685 Contact ID....................................................................................................................................................8–14
8.5.5 MX8000/685 System Messages ......................................................................................................................8–20
8.6 CAPS Automation Protocol ..............................................................................................................................8–20
8.7 FBII CP-220 Automation Protocol ...................................................................................................................8–22
8.7.1 3x1, 4x1, and 4x2 Automation Protocols........................................................................................................8–22
8.7.2 Acron 11 Digit with Zero or Space...................................................................................................................8–22
8.7.3 FBII Superfast.....................................................................................................................................................8–22
8.7.4 CP-220 Contact ID.............................................................................................................................................8–22
8.7.5 CP-220/Silent Knight .........................................................................................................................................8–23
8.7.6 MX8000/CP-220 System Messages ...............................................................................................................8–24
8.8 SK9000 Protocol ................................................................................................................................................8–25
8.8.1 Data String Description And Special Characters...........................................................................................8–25
8.8.2 Calls From Panels..............................................................................................................................................8–26
8.8.3 Long Calls ...........................................................................................................................................................8–26
8.8.4 Bad Data..............................................................................................................................................................8–27
8.8.5 Good Data with Bad Data .................................................................................................................................8–27
8.8.6 Validation Byte (V-Byte) ....................................................................................................................................8–27
8.8.7 System Messages..............................................................................................................................................8–28
8.8.8 Communication from a Computer to the MX8000.........................................................................................8–28
8.9 ITI Generic Computer Format ..........................................................................................................................8–29
8.9.1 Convention Used In This Section ....................................................................................................................8–29
8.9.2 Report Record ....................................................................................................................................................8–29
8.9.3 Log Record..........................................................................................................................................................8–31
8.9.4 Test Record ........................................................................................................................................................8–32
8.9.5 OKAY Record .....................................................................................................................................................8–32
8.9.6 ACKing and NACKing Data ..............................................................................................................................8–32
8.10 ITI Computer Interface Format.........................................................................................................................8–32
8.10.1 Convention Used In This Section ....................................................................................................................8–32
8.10.2 General Record Structure.................................................................................................................................8–33
8.10.3 Report Record ....................................................................................................................................................8–33
8.10.4 Test Record ........................................................................................................................................................8–36
8.10.5 Supervisory Record ...........................................................................................................................................8–37
8.10.6 Log Records........................................................................................................................................................8–37
8.10.7 Checksum/Control Field....................................................................................................................................8–37
8.11 US ASCII Character Code ................................................................................................................................8–38
Appendix A Programming Quick Chart ................................................................................................................... A–1
Appendix B Receiver Update Procedure................................................................................................................. B–1
Appendix C Index .......................................................................................................................................................... C–1