Honeywell MX8000 - Page 61

Section 5 – Programming
5–5
Table 5–2: General Options Items and Description (cont’d)
General Options
Items
Level 1 Choices Level 2 Choices Level 3 Choices Comments
<Cfg>
Term = 013, Head =
010, ACK = 006,
NACK = 021, TR =
005, TH = 084, TT =
020
Only visible if ADEMCO 685, FBII220,
or CAPS ONLY format is selected.
Note: Setting ACK and NACK to 0
disables the ACK and NACK.
Y = Enabled
Log Records
N = Disabled
Y = Enabled Enable
External ID
N = Disabled
Supervisory
Character
No Data
Character
6.1
Automation Config
(continued)
<ITI>
Generic
Revision
6.2
Only visible if ITI Gen or ITIComp
format is selected.
Printer Yes or No See Section 5.4.3.6.
Bkp Printer Yes or No
Auto Comp Yes or No
Bkp Auto Comp Yes or No
Battery Yes or No
Device Yes or No Device corresponds to loss of com-
munication with slave or line card.
Line Fault Yes or No
AC Power Yes or No
Buffer Full Yes or No
Listen In Yes or No Listen in must be set to No for UL
installations.
Annunciator
Configuration
Call Pending Yes or No
Printer Yes or No See Section 5.4.3.7.
Bkp Printer Yes or No
Auto Comp Yes or No
Bkp Auto Comp Yes or No
Battery Yes or No
Device Yes or No Device corresponds to loss of com-
munication with slave or line card.
Line Fault Yes or No
AC Power Yes or No
Buffer Full Yes or No
Listen In Yes or No Listen in must be set to No for UL
installations.
Communication
(continued)
Aux Relay Cfg
Call Pending Yes or No
No Battery Bkp See Section 5.4.4.
Battery Bkp
Battery Backup
Cfg
DC Bkp
Receiver Mode MstrAuto, MstrPrn,
SlvAuto, SlvPrn, or
Single
System Options
Receiver ID No. 01-99