Honeywell MX8000 - Page 67

Section 5 – Programming
5–11
7. Press
ENTER
MENU
to change the setting of that option.
Note: Additional presses of the enter button will toggle the setting between Yes and No.
8. Repeat steps 6 and 7 for any other ITI display options you wish to edit.
5.4.2.6 How to Edit Format Options
To set these display options follow these steps:
1. Enter program mode. (See Section 5.1.)
2. Press
1
for general options.
3. Press
2
for display options.
4. Press
until the display flashes on the <FMT> savings field.
5. Press
ENTER
MENU
.
6. Press the
or button until the equal sign is on the desired option.
7. Press
ENTER
MENU
to change the setting of that option from “English” to “Code”.
For Pulse Format “0 to 9” or “0 to F” can be selected. For SK9000 “Packed or Unpacked” can be selected.
Note: Additional presses of the enter button will toggle the setting between English and Code.
8. Repeat steps 6 and 7 for any other FMT options you wish to edit.
5.4.2.7 How to Set Hold Last Event
Hold last event will cause the VFD to display the last acknowledged event instead of the date/time display in
the auto mode. In manual mode the display will show the oldest unacknowledged event. To set the hold last
event function, proceed as follows:
1. Enter program mode. (See Section 5.1.)
2. Press
1
for general options.
3. Press
2
for display options.
4. Press
until the display flashes on the hold last event field.
5. Press the
or button until the display flashes on the desired setting.
6. Press
ENTER
MENU
.
5.4.2.8 How to Set VFD Brightness
Note: This field affects the Normal Operating Display screen ONLY. All other displays will be shown at
maximum.
1. Enter program mode. (See Section 5.1.)
2. Press
1
for general options.
3. Press
2
for display options.