Honeywell MX8000 - Page 75

Section 5 – Programming
5–19
3. Press
3
for communications.
4. Press
5
to set up automation configuration.
5. Press
until the time field is flashing.
6. From the number keypad enter the desired number or press the
or button until the display
flashes on the desired setting.
7. Press
ENTER
MENU
.
8. If you wish to exit, press
until you exit this menu.
Ack Time (Acknowledge Time)
The acknowledge time is the duration that the receiver will wait for a response from the automation
computer after a data packet has been sent. Data packets include all reports and heartbeats.
Follow these steps to set the time period or the heartbeat:
1. Enter program mode. (See Section 5.1.)
2. Press
1
for general options.
3. Press
3
for communications.
4. Press
5
to set up automation configuration.
5. Press
until the ack time field is flashing.
6. From the number keypad enter the desired number or press the
or button until the display
flashes on the desired setting.
7. Press
ENTER
MENU
.
8. If you wish to exit, press
until you exit this menu.
ITI Options (Only Visible if ITI Gen or ITIComp Formats are Chosen)
These are options particular to the ITI automation format and can only be edited if one of these formats is
used to communicate with the automation computer. See Sections 8.8 and 8.10.
Follow these steps to set the ITI options:
1. Enter program mode. (See Section 5.1.)
2. Press
1
for general options.
3. Press
3
for communications.
4. Press
5
to set up automation configuration.
5. Press
until the ack <ITI> field is flashing.
6. Press
ENTER
MENU
.