Honeywell MX8000 - Page 96

MX8000 Installation and Operation Guide
5–40
To Change the Format Group:
1. Follow the procedures in Section 5.5.2.
2. Press
1
for handshake sequence menu.
3. Press
until the display flashes on the Format Group field. See Table 5–11 for valid entries.
4. Press the
or button to change the format group. See Table 6–1 in Section 5 for your
communication format.
5. When the desired format group is flashing press
ENTER
MENU
or .
To Change the Handshake Duration Time:
The handshake duration is the length of time that the receiver will send a handshake tone. See Table 5–11
for valid entries.
1. Follow the procedures in Section 5.5.2.
2. Press
1
for handshake sequence menu.
3. Press
until the display flashes on the Dur field.
4. Enter the desired value from the keypad or press the or button to change the handshake
duration time.
5. When the desired handshake duration time is flashing press
ENTER
MENU
or .
To Change the Maximum Handshake Wait Time:
The wait time is the amount of time the receiver will wait for data from the reporting panel before
outputting the next handshake sequence. See Table 5–11 for valid entries.
1. Follow the procedures in Section 5.5.2.
2. Press
1
for handshake sequence menu.
3. Press
until the display flashes on the Wait field.
4. Enter the desired value from the keypad or press the or button to change the wait time.
5. When the desired wait time is flashing press
ENTER
MENU
or .
To Change the Acknowledgment Tone Duration Time:
The acknowledgment tone duration time is the amount of time the receiver will send an acknowledgment
tone to the reporting panel. See Table 5–11 for valid entries.
1. Follow the procedures in Section 5.5.2.
2. Press
1
for handshake sequence menu.
3. Press
until the display flashes on the AckDur field.
4. Enter the desired value from the keypad or press the or button to change the acknowledg-
ment tone duration time.