EasyManuals Logo

Honeywell XENON 1902 User Manual

Honeywell XENON 1902
376 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
Xenon/Granit User Guide 97
Override Locked Scanner
If you need to replace a broken or lost scanner that is linked to a base, scan the
Override Locked Scanner bar code below with a new scanner and place that scan-
ner in the base. The locked link is overridden, the broken or lost scanner’s link with
the base is removed, and the new scanner is linked to the base.
Out-of-Range Alarm
If your scanner is out range of the base, an alarm sounds from both your base and
scanner. The alarm stops when the scanner is moved closer to the base, when the
base connects to another scanner, or when the alarm duration expires. To activate
the alarm options for the scanner or the base and to set the alarm duration, scan
the appropriate bar code below and then set the time-out duration (from 0-3000
seconds) by scanning digits on the Programming Chart, beginning on page 353,
then Save.
Note: If you are out of range when you scan a bar code, you will receive an error tone even if
you do not have the alarm set. You receive the error tone since the data could not be
communicated to the base or the host.
Alarm Sound Type
You may change the alarm type for the scanner or a base by scanning the appropri-
ate bar code below and then scanning a digit (0-7) bar code from the Programming
Chart, beginning on page 353, then Save. Default = 0.
The sounds are as follows:
Override Locked Scanner
(Single Scanner)
Base Alarm Duration
Scanner Alarm Duration
Setting Sound
0 3 long beeps, medium pitch
1 3 long beeps, high pitch
2 4 short beeps, medium pitch

Table of Contents

Other manuals for Honeywell XENON 1902

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell XENON 1902 and is the answer not in the manual?

Honeywell XENON 1902 Specifications

General IconGeneral
Operating frequency2400 - 2500 MHz
Standard interfacesBluetooth
Connectivity technologyWireless
Sensor typeLaser
Scanner type1D/2D
Pitch reading angle-45 - 45 °
Light levels (direct sunlight)0 - 100000 lx
Linear (1D) barcodes supported-
Battery life14 h
Charging time4.5 h
Input voltage5 V
Battery capacity1800 mAh
Power source typeBattery
Number of reads per charge50000
Power consumption (standby)0.5 W
ShockproofYes
CertificationCE, UL
Product colorBlack
International Protection (IP) codeIP41
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 50 °C
Operating relative humidity (H-H)0 - 95 %
Sustainability certificatesRoHS
Weight and Dimensions IconWeight and Dimensions
Depth104 mm
Width71 mm
Height160 mm
Weight214 g
Base weight179 g
Base dimensions132 x 102 x 81 mm

Related product manuals