154 Xenon/Granit User Guide
Out-of-Range Alarm Volume
Note: This setting is not supported by the Xenon 1900h scanner.
If your scanner is out range of the base, an alarm sounds from both your base and
scanner. If your scanner is out range of an Access Point, an alarm sounds from just
the scanner. The alarm stops when the scanner is moved closer to the base or
Access Point, when the base or Access Point connects to another scanner, or when
the alarm duration expires (see Out-of-Range Delay on page 155). The following
settings set the Out-of-Range Alarm for the base and the scanner, independent of
the volume used when scanning bar codes. Default = Base Alarm Volume Low,
Scanner Alarm Volume Low.
* Scanner Alarm Volume
Low
Scanner Alarm Volume
Medium
To Next Page
Loading...
