Honeywell XENON 1902

70 Xenon/Granit User Guide
linked to another Access Point, it will be updated with the new base/Access Point
settings for whatever work group to which that the scanner was previously
assigned. For example, if the scanner was in work group 1 linked to the first base, it
will be placed in work group 1 in the second base with the associated settings.
Application Work Group Selection
This programming selection allows you to assign a scanner to a work group by
scanning the bar code below. You may then program the settings (e.g., beeper vol-
ume, prefix/suffix, data formatter) that your application requires. Default = Group 0.
Reset the Factory Defaults: All Application Work Groups
The following bar code defaults all of the work groups to the factory default set-
tings.
* Group 0
Group 1
Group 2
Group 3
Group 4
Group 5
Group 6
Factory Default Settings:
All Work Groups