Honeywell XENON 1902 User Manual

Xenon/Granit User Guide 155
Out-of-Range Delay
Note: This setting is not supported by the Xenon 1900h scanner.
When using the Out-of-Range Alarm settings, the length of the delay for the alarm
is set with an Out-of-Range Delay. When the scanner is out of range of the base or
Access Point, the alarm will delay for a set length of time before going off. Set the
length (in seconds) for a timeout by scanning the following bar code, then setting
the timeout (from 0-3,000 seconds) by scanning digits from the Programming
Chart, beginning on page 353, then Save. Default = No Delay.
Base Alarm Volume
High
Scanner Alarm Volume
High
Out-of-Range Delay

Honeywell XENON 1902 Specifications

General

Operating frequency	2400 - 2500 MHz
Standard interfaces	Bluetooth
Connectivity technology	Wireless
Sensor type	Laser
Scanner type	1D/2D
Pitch reading angle	-45 - 45 °
Light levels (direct sunlight)	0 - 100000 lx
Linear (1D) barcodes supported	-
Battery life	14 h
Charging time	4.5 h
Input voltage	5 V
Battery capacity	1800 mAh
Power source type	Battery
Number of reads per charge	50000
Power consumption (standby)	0.5 W
Shockproof	Yes
Certification	CE, UL
Product color	Black
International Protection (IP) code	IP41
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Sustainability certificates	RoHS

Weight and Dimensions

Depth	104 mm
Width	71 mm
Height	160 mm
Weight	214 g
Base weight	179 g
Base dimensions	132 x 102 x 81 mm