Xenon/Granit User Guide 263
Application Plug-Ins (Apps)
Any apps that you are using can be turned off or on by scanning the following bar
codes. Apps are stored in groups: Decoding, and Formatting. You can enable and
disable these groups of apps by scanning that group’s On or Off bar code below.
You can also scan the List Apps bar code to output a list of all your apps.
Note: You must reset your device in order for the apps setting to take effect.
EZConfig Cloud for Scanning Introduction
EZConfig Cloud for Scanning provides a wide range of PC-based programming
functions that can be performed on a scanner connected to your PC. EZConfig
Cloud for Scanning allows you to download upgrades to the scanner's firmware,
change programmed parameters, and create and print programming bar codes.
Using EZConfig Cloud for Scanning, you can even save/open the programming
parameters for a scanner. This saved file can be e-mailed or, if required, you can
create a single bar code that contains all the customized programming parameters
and mail or fax that bar code to any location. Users in other locations can scan the
bar code to load in the customized programming.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
