146 Xenon/Granit User Guide
(if turned on) for each read. If using a Granit scanner, the scanner also vibrates. The
scanner attempts to find and decode new symbols as long as the trigger is pulled.
When this programming selection is turned Off, the scanner will only read the sym-
bol closest to the aiming beam. Default = Off.
No Read
With No Read turned On, the scanner notifies you if a code cannot be read. If using
an EZConfig-Scanning Tool Scan Data Window (see page 263), an “NR” appears
when a code cannot be read. If No Read is turned Off, the “NR” will not appear.
Default = Off.
If you want a different notation than “NR,” for example, “Error,” or “Bad Code,” you
can edit the output message (see Data Format beginning on page 167). The hex
code for the No Read symbol is 9C.
Video Reverse
Video Reverse is used to allow the scanner to read bar codes that are inverted. The
Video Reverse Off bar code below is an example of this type of bar code. Scan
Video Reverse Only to read only inverted bar codes. Scan Video Reverse and
Standard Bar Codes to read both types of codes.
Note: After scanning Video Reverse Only, menu bar codes cannot be read. You must scan
Video Reverse Off or Video Reverse and Standard Bar Codes in order to read menu
bar codes.
Note: Images downloaded from the unit are not reversed. This is a setting for decoding only.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
