EasyManuals Logo

Honeywell XENON 1902 User Manual

Honeywell XENON 1902
376 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #171 background imageLoading...
Page #171 background image
Xenon/Granit User Guide 151
Low Beeper (Daytime Mode)
The following bar code sets all sounds to on, but at a low volume. The scanner
beep, base beep, base and scanner power up beep, and scanner linking sounds are
all set to low volume.
To reset your scanner and base to default sounds, refer to Reset the Custom
Defaults (page 271).
Quiet Operations - LED and Volume Settings
If you have silenced or muted the scanner and base sounds, you may wish to adjust
the visual (LED) indicators for Bluetooth linking sounds, scanning sounds, paging
sounds, and out of range alarm sounds.
Linking LED Colors and Sound
Note: This setting is not supported by the Xenon 1900h scanner.
Under normal operations, the scanner chirps when linking to a base or an access
point, and the LED on both the base and scanner flash green. If you want to silence
all sounds and set both devices to flash red LEDs to indicate the linking status,
scan the Red LED Flashes/Silent bar code below. The LEDS flash red while link-
ing, then green to indicate the base and scanner are linked. To return to the default
LED colors and sound, scan Green LED Flashes/Sound. Default = Green LED
Flashes/Sound.
Daytime Mode -
Cordless Scanner and Base
Daytime Mode -
Corded Scanner
* Green LED Flashes/Sound
Red LED Flashes/Silent

Table of Contents

Other manuals for Honeywell XENON 1902

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell XENON 1902 and is the answer not in the manual?

Honeywell XENON 1902 Specifications

General IconGeneral
Operating frequency2400 - 2500 MHz
Standard interfacesBluetooth
Connectivity technologyWireless
Sensor typeLaser
Scanner type1D/2D
Pitch reading angle-45 - 45 °
Light levels (direct sunlight)0 - 100000 lx
Linear (1D) barcodes supported-
Battery life14 h
Charging time4.5 h
Input voltage5 V
Battery capacity1800 mAh
Power source typeBattery
Number of reads per charge50000
Power consumption (standby)0.5 W
ShockproofYes
CertificationCE, UL
Product colorBlack
International Protection (IP) codeIP41
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 50 °C
Operating relative humidity (H-H)0 - 95 %
Sustainability certificatesRoHS
Weight and Dimensions IconWeight and Dimensions
Depth104 mm
Width71 mm
Height160 mm
Weight214 g
Base weight179 g
Base dimensions132 x 102 x 81 mm

Related product manuals