122 Xenon/Granit User Guide
Presentation Mode
Presentation Mode uses ambient light and scanner illumination to detect bar
codes. When in Presentation Mode, the LEDs remain dim until a bar code is pre-
sented to the scanner, then the aimer turns on and the LEDs turn up to read the
code. If the light level in the room is not high enough, Presentation Mode may not
work properly
Note: If you are using a cordless charge base in Presentation Mode, the battery will not
charge unless the power supply is plugged into the base’s auxiliary power port.
Scan the following bar code to program your scanner for Presentation Mode.
Presentation LED Behavior after Decode
When a scanner is in presentation mode, the LED aimer dims 30 seconds after a
bar code is decoded. If you wish to dim the LED aimer immediately after a bar code
is decoded, scan the LEDs Off bar code, below. Default = LEDs On.
Presentation Sensitivity
Presentation Sensitivity is a numeric range that increases or decreases the scan-
ner's reaction time to bar code presentation. To set the sensitivity, scan the Sensi-
tivity bar code, then scan the degree of sensitivity (from 0-20) from the
Programming Chart, beginning on page 353, then Save. 0 is the most sensitive
setting, and 20 is the least sensitive. Default = 1.
Note: Granit 1980i and 1981i do not support this setting.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
