Xenon/Granit User Guide 69
You may also scan the Scanner Name bar code below and scan a number for the
scanner name. For example, if you wanted to name the linked scanner “312,” you
would scan the bar code below, scan the 3, 1, and 2 bar codes on the Programming
Chart, beginning on page 353, then Save. Scan the Reset bar code and wait for the
scanner to relink to the base.
Application Work Groups
Your cordless system can have up to 7 scanners linked to one base or Access Point.
You can also have up to 7 work groups. If you want to have all of the scanners’ set-
tings programmed alike, you don’t need to use more than 1 work group. If you want
each scanner to have unique settings (e.g., beeper volume, prefix/suffix, data for-
matter), then you may program each scanner to its own unique work group and
may program each scanner independently. For example, you might want to have
multiple work groups in a retail/warehouse application where you need to have dif-
ferent data appended to bar codes used in the warehouse area versus the retail
area. You could assign all the scanners in the retail area to one work group and
those in the warehouse to another. Consequently, any desired changes to either the
retail or warehouse area would apply to all scanners in that particular work group.
Honeywell’s online configuration tool, EZConfig-Scanning (page 262), makes it
easy for you to program your system for use with multiple scanners and multiple
work groups.
The scanner keeps a copy of the menu settings it is using. Whenever the scanner is
connected or reconnected to a base or an Access Point, the scanner is updated
with the latest settings from the base or Access Point for its work group. The scan-
ner also receives menu setting changes processed by the base or Access Point. If a
scanner is removed from a base or an Access Point and placed into another base or
To Next Page
Loading...
Need help?
General
Weight and Dimensions
