EasyManuals Logo

Honeywell XENON 1902 User Manual

Honeywell XENON 1902
376 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #177 background imageLoading...
Page #177 background image
CHAPTER
7
Xenon/Granit User Guide 157
DIRECT PART MARK (DPM)
SETTINGS
The following settings have been developed for the Granit 1920i scanner and are
supported only by that device.
DPM Illumination Settings
Cycle Illumination
This is the default setting for the Granit 1920i. Cycle Illumination cycles through
the Direct Illumination - Top and Bottom, and Indirect Illumination settings. It is
best used when there is a mix of codes to be scanned.
To further refine the scanner’s ability to read DPM codes, scan one of the following
four illumination setting codes. Only one of these illumination settings can be used
and these settings may be faster than Cycle Illumination.
Low Contrast Codes
This setting is recommend when reading very low contrast bar codes. Scan the fol-
lowing code to program the scanner to cycle through both Direct Illumination - Top
and Bottom and Indirect Illumination with multiple exposure settings.
Cycle Illumination
Low Contrast Codes

Table of Contents

Other manuals for Honeywell XENON 1902

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell XENON 1902 and is the answer not in the manual?

Honeywell XENON 1902 Specifications

General IconGeneral
Operating frequency2400 - 2500 MHz
Standard interfacesBluetooth
Connectivity technologyWireless
Sensor typeLaser
Scanner type1D/2D
Pitch reading angle-45 - 45 °
Light levels (direct sunlight)0 - 100000 lx
Linear (1D) barcodes supported-
Battery life14 h
Charging time4.5 h
Input voltage5 V
Battery capacity1800 mAh
Power source typeBattery
Number of reads per charge50000
Power consumption (standby)0.5 W
ShockproofYes
CertificationCE, UL
Product colorBlack
International Protection (IP) codeIP41
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 50 °C
Operating relative humidity (H-H)0 - 95 %
Sustainability certificatesRoHS
Weight and Dimensions IconWeight and Dimensions
Depth104 mm
Width71 mm
Height160 mm
Weight214 g
Base weight179 g
Base dimensions132 x 102 x 81 mm

Related product manuals