Honeywell XENON 1902 User Manual

Xenon/Granit User Guide 265
If you aren’t sure what programming options are in your scanner, or you’ve
changed some options and want to restore the scanner to factory default settings,
first scan the Remove Custom Defaults bar code, then scan Activate Defaults.
This resets the scanner to the factory default settings.
Note: If using a cordless system, scanning the Activate Defaults bar code also causes both
the scanner and the base or Access Point to perform a reset and become unlinked.
The scanner must be placed in its base to re-establish the link before any setup codes
are entered. If using an Access Point, the linking bar code must be scanned. See
Cordless System Operation: Xenon 1902g/1912 and Granit 1911i/1981i beginning
on page 43,or Cordless System Operation: Xenon 1902g-BF beginning on page 81
for additional information.
The Menu Commands, beginning on page 272, list the factory default settings for
each of the commands (indicated by an asterisk (*) on the programming pages).
Remove Custom Defaults
Activate Defaults

Honeywell XENON 1902 Specifications

General

Operating frequency	2400 - 2500 MHz
Standard interfaces	Bluetooth
Connectivity technology	Wireless
Sensor type	Laser
Scanner type	1D/2D
Pitch reading angle	-45 - 45 °
Light levels (direct sunlight)	0 - 100000 lx
Linear (1D) barcodes supported	-
Battery life	14 h
Charging time	4.5 h
Input voltage	5 V
Battery capacity	1800 mAh
Power source type	Battery
Number of reads per charge	50000
Power consumption (standby)	0.5 W
Shockproof	Yes
Certification	CE, UL
Product color	Black
International Protection (IP) code	IP41
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Sustainability certificates	RoHS

Weight and Dimensions

Depth	104 mm
Width	71 mm
Height	160 mm
Weight	214 g
Base weight	179 g
Base dimensions	132 x 102 x 81 mm