HP 1660 Series Training Guide

4 Run Measurement
Select single or repetitive From any Analyzer or Scope menu, select
the field labeled Run in the upper right corner to start the measurement,
or press the Run key. A "single" run will run once, until memory is full; a
"repetitive run" will run until you select Stop or until a stop measurement
condition is fulfilled, which you set in the markers menu.
Using the Analyzer and Understanding the Measurement Process
Understanding the Measurement Process
1–7
Get other manuals https://www.bkmanuals.com

HP 1660 Series Specifications

General

Category	Logic Analyzer
Glitch Trigger	Yes
Pattern Trigger	Yes
State Analysis	Yes
Transitional Timing	Yes
Trigger Modes	Edge, Pattern, Glitch