HP 1660 Series Training Guide

Measure the Clock Period Manually 7–8
Measure the Clock Period with Auto Measure 7–9
Read Voltage with the Markers 7–10
8 Triggering the Oscilloscope with the Timing Analyzer
Before You Begin 8–3
Set the Jumpers 8–4
Connect the Oscilloscope Probe 8–5
Get the Waveform on the Display 8–6
Change the Oscilloscope Trigger 8–7
Turn On the Timing Analyzer 8–8
Set Up the Timing Format Menu 8–9
Define the Timing Trigger Term "Edge 1" 8–10
Set Up the Timing Trigger Specification 8–11
Arm the Oscilloscope with the Timing Analyzer 8–12
Add Oscilloscope Waveform to the Timing Waveforms 8–13
Capture the Glitch with the Timing Analyzer and Oscilloscope 8–14
Align the Glitch Displayed by the Oscilloscope and Analyzer 8–15
9 Using the Pattern Generator
Before You Begin 9–3
Connect the Pattern Generator 9–4
Turn On the Timing Analyzer 9–5
Change a Label Name 9–6
Modify Channel Assignments 9–7
Set Up the Timing Analyzer Trigger Term 9–8
Add a Pattern Generator Label to the Timing Waveform Display 9–9
Set Up the Pattern Generator Format Menu 9–10
Program the Pattern Generator Output 9–12
Add Program Lines 9–13
Start the Pattern Generator and View the Walking Ones Pattern 9–14
Stop the Pattern Generator 9–15
Contents
ix
Get other manuals https://www.bkmanuals.com

HP 1660 Series Specifications

General

Category	Logic Analyzer
Glitch Trigger	Yes
Pattern Trigger	Yes
State Analysis	Yes
Transitional Timing	Yes
Trigger Modes	Edge, Pattern, Glitch