475
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
process-id: Specifies an OSPFv3 process by its ID in the range of 1 to 65535. If you do not specify this
argument, the command displays the OSPFv3 route information for all processes.
ipv6-address prefix-length: Specifies an IPv6 address. The ipv6-address argument specifies an IPv6 prefix.
The prefix-length argument specifies a prefix length in the range of 0 to 128.
Examples
# Display OSPFv3 routing information.
<Sysname> display ospfv3 routing
OSPFv3 Process 1 with Router ID 9.9.9.9
-------------------------------------------------------------------------
I - Intra area route, E1 - Type 1 external route, N1 - Type 1 NSSA route
IA - Inter area route, E2 - Type 2 external route, N2 - Type 2 NSSA route
* - Selected route
*Destination: 3::3/128
Type : I Cost : 0
Nexthop : :: Interface: Loop1
AdvRouter : 9.9.9.9 Area : 0.0.0.0
Preference : 10
*Destination: 4::4/128
Type : I Cost : 1
Nexthop : FE80::20C:29FF:FED4:7171 Interface: Vlan2
AdvRouter : 8.8.8.8 Area : 0.0.0.0
Preference : 10
*Destination: 6::/64
Type : I Cost : 1
Nexthop : :: Interface: Vlan2
AdvRouter : 9.9.9.9 Area : 0.0.0.0
Preference : 10
Total: 3
Intra area: 3 Inter area: 0 ASE: 0 NSSA: 0
Table 125 Command output
Field Descri
tion
Destination Destination network segment.
Type Route type.
To Next Page
Loading...
Need help?
General
