6-79. Separating the Amplitude and Phase Components of Test-Device-Induced
Modulation
...............................
6-144
6-80. Range of a Forward Transform Measurement
................
6-145
6-81.
ParaIIel
Port Input and Output Bus Pin Locations in GPIO Mode
.......
6-149
6-82. Amplifier Parameters
............................
6-153
6-83. Swept Frequency Amplifier Measurement of Absolute Fundamental,
2nd
and
3rd
Harmonic Output Levels
........................
6-153
6-84. Swept Frequency Amplifier Measurement of
2nd
and
3rd
Harmonic Distortion
(dBc)
.................................
6-154
6-85. Diagram of Gain Compression
.......................
6-155
6-86. Swept Power Measurement of Amplifier’s Fundamental Gain Compression and
2nd
Harmonic Output Level
.......................
6-155
6-87. Test Configuration for Setting RF Input using Automatic Power Meter Calibration 6-156
6-88. Mixer Parameters
.............................
6-158
6-89. Conversion Loss versus Output Frequency Without Attenuators at Mixer Ports
6-159
6-90. Example of Conversion Loss versus Output Frequency Without Correct IF
SiiaI
Path Filtering
.............................
6-160
6-91. Example of Conversion Loss versus Output Frequency With Correct IF Signal
Path Filtering and Attenuation at
aII
Mixer Ports
.............
6-160
6-92. Examples of Up Converters and Down Converters
..............
6-161
6-93. Down Converter Port Connections
.....................
6-162
6-94. Up Converter Port Connections
.......................
6-163
6-95. Example Spectrum of RF, LO, and IF
Signals
Present in a Conversion Loss
Measurement.
.............................
6-164
6-96. Main Isolation
Terms
............................
6-164
6-97. Conversion Loss and Output Power as a Function of Input Power Level
....
6-166
6-98. Connections for an Amplitude and Phase Tracking Measurement Between Two
Mixers
.................................
6-167
6-99. Adapter Considerations
..........................
6- 169
7-l.
External
Trigger Circuit
..........................
7-18
11-l.
Peripherd
Connections to the Analyzer
...................
11-8
11-2. HP-IB Bus Structure
............................
11-17
11-3.
AnaIyzer
Siie Bus Concept
........................
11-20
B-l. Error Model
Flowgraph
..........................
B-13
Contents-21
To Next Page
Loading...
