HP 8753E - Page 630

If the Peripheral Is a Power Meter
..i .;
2. press ~~~~~~~~~~~.‘~~~~~ until the come& s&&ion appears:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...’
q HP 436A
q HP 437B or 438A
,, “‘8”‘. ““‘(” :p
3. fiess ~~~~‘~.~~~.~:~~~~~~~~ ad configure the power meter a folJows:
i :... :. .:::: :::::: .._... i....... /,.::..:
a. Enter the HP-IB address of the power meter, followed by @.
‘,~,.,~,~,~,,~,,~, .,,
_ _ _ _ _ _ / _ _ _
b. Press (Local) and @@#J ~~~~~~~~ if there is no external controller connected to the
HP-IB bus.
.,. .; ,..,.,.,...,.,. .,. _
.::: ::
c. press m ad :~~~~,~~~~~~~~~~~~~ if there is a e&g-naJ controller coMe&ed to the
.._............................................-................................... : . . . . . . . i ::..
HP-IB bus.
If the Peripheral Is an External Disk Drive
: ,,.,:,:.,... ,.
_ .,., ,.
1. mess (Local) ~~~~‘~~~~~~~~ ad enter the &+ve where your && is located, followed by
i..i i . . . . . . . . .../ /;;./..i_/;;;.i
@].
/ .,., ,. ., . . . . . .
3. If your storage disk is partitioned, press ~~~~:.~~~ and enter the volume number
.i /ii L/
where you want to store the instrument state tile.
4. Press (Local] and select one of the following:
..: .:,:,:..,.; ;.,
n Choose ~~~~~~~~~~~~~, if there is no extemal controller coMected.
..--..........--............
/ ..;;::z:.
n Choose ~~~~~~~~ when an etiemal controuer is coMected and *e andyzer needs
;: /............ . ...*.* ...*. ...*...;..
.._ . . . . . _...............
to control peripherals directly. This mode causes the analyzer to request control from the
external controlier whenever it needs to communicate with a peripheral.
If the Peripheral Is a Computer Controller
2. Press ILocal and select one of the following:
i_i _ i_
. C.,oose ~~~~~~~~ to flow the computer controuer to be involved h d
.._._.........._...-.......-..............-............... .._
peripheral access operations
:<.:.:.:.:.::.~.:.:.:.:.*:;. ,~~...~.:.~:.~~.:.:.:.:.:.:.:...::.:.:.:.:.:.:.:~.:.~:.~~:
n Choose ~~~~~~~~~ when an external controller is connected and the analyzer needs
.*
..-.................. - .._...
to control peripherals directly. This mode causes the analyzer to request control from the
external controller whenever it needs to communicate with a peripheral.
Compatible Peripherals 1 l-13