B-26 Appendix B
Support Information
---Boot Help ------------------------------------------------------
BOot continues the boot sequence from the specified path.
The primary boot path is normally the disk containing
the operating system.
The alternate path is normally a tape device.
BOot Boot from primary path
BOot PRImary Boot from primary path
BOot ALTernate Boot from alternate path
BOot LAN<.lan path>INSTALL Boot from HP-UX Install server
BOot
<p
ath>
Boot
from
speci
fied
path
<.lan path> is a delimiter '.' followed by either
an IP address, such as 10.6.6.6
or a lan address, such as 080009-123abc.
lan path can be omitted to broadcast the
request for boot from an install server.
<path> is either in I/O notation, such as 1/2/3.4.5.6
or
<pa
th
labe
l>
forma
t,
such
as
P0,
P1,
...
P19
Short command for BOot: bo
----
---Default Help---------------------------------------------------
DEfault initializes system Stable Storage values to their defaults
based on the system configuration.
DEfault set the following values:
Primary Path 4.5
Alternate Path 16/5.0
Console Path 0.0
Keyboard Path 16/7.0
Autoboot OFF
Autosearch OFF
Short command for DEfault: de
----
---Eepromread Help ---------------------------------------------------
EepromRead reads and displays Firmware EEPROM locations.
EepromRead Display entire contents of EEPROM
EepromR
ead
<addr>
Displa
y
64
words
of
EEPR
OM
start
ing
EEpromR
ead
<addr><
len>
Displa
y
<len>
words
of
EEPRO
M
starting
<addr>: hex or decimal byte offset in EEPROM (default = 0)
<len> : number of words to display (default = 64 words)
Short command for EEpromRead: er
----
To Next Page
Loading...
Need help?
General
