HP EVA P6000 User Manual

2. Run the Xtend SAN application to discover and configure the EVA iSCSI targets. The Xtend
SAN iSCSI Initiator can discover targets either by static address or iSNS.
For static address discovery:
a. Select Discover Targets and then select Discover by DNS/IP (Figure 36 (page 94)).
Figure 36 Discover targets
b. Add the static IP address of the iSCSI or iSCSI/FCoE module's port in the Address field
and then select Finish (Figure 37 (page 94)).
Figure 37 Add static IP address
c. Select a target from the Discovered Target list and then click Add (Figure 36 (page 94)).
NOTE: The iSCSI or iSCSI/FCoE module's port may present several iSCSI targets to
the Xtend SAN iSCSI Initiator. Select only one target from the list.
94 iSCSI or iSCSI/FCoE configuration rules and guidelines

HP EVA P6000 Specifications

General

Model	HP EVA P6000
Number of Storage Controllers	2
Management Software	HP Command View EVA
Drive Types	SAS, SSD
RAID Levels	RAID 0, 1, 5, 6
Connectivity	8 Gb Fibre Channel, 10 Gb iSCSI, 1 Gb iSCSI
Form Factor	Rack-mounted
Storage Controller Type	Dual controllers