HP Integrity BL860c User Manual

PCI Device, and PCI Function to the Bus #, Dev #, and Fnc # values from the
info io command.
CAUTION: Do not change the value for any of these fields on the Adapter Properties screen:
• Auto Termination
• Parity
• Bus Scan Order
• Spinup Delay (Secs)
Changing any of these fields can cause unpredictable results.
CAUTION: Do not change the value for any of these fields on the Device Properties screen:
• Scan Id
• Scan LUNs > 0
• Disconnect
• Timeout
• Queue Tags
• Format
• Verify
Changing any of these fields can cause unpredictable results.
7. Display (and optionally change) any parameters listed below for the channel of the interface,
or restore its parameters to their default values.
• ID
• Maximum data transfer rate
• Bus width
• Whether the interface is bootable (driver support)
• Avoid bus resets (secondary cluster server)
• Restore Defaults
8. Use the arrow keys to navigate to the appropriate parameter.
9. Use the plus (+) and minus (-) keys to scroll through the values until the value you want displays.
10. To exit the Adapter Properties screen, press Esc. You are given these choices:
• Cancel the exit from the screen (to stay in the Adapter Properties screen for the channel
of the interface)
• Save the changes you made and exit the screen
• Discard the changes you made and exit the screen
11. Move the cursor to the action (cancel, save, or discard) you want to take; press Enter.
If you selected cancel, you remain in the Adapter Properties screen for the channel of the
interface. You can still change the channel’s parameters listed above.
If you selected save or discard, you go to the EFI Setup Utility main menu.
CAUTION: Do not select the <Global Properties> option on the main menu.
12. Press Esc to exit the main menu and the EFI Setup Utility.
13. Select the option for exiting the utility.
14. When prompted, press Enter to stop the interface; you are at the EFI Shell prompt.
15. At the EFI Shell prompt, enter the reset command. The server starts to reboot. This is required
to cause the new setting.
Specifying Parameters 173

HP Integrity BL860c Specifications

General

Brand	HP
Model	Integrity BL860c
Category	Server
Language	English