Chapter 4
Removing and Replacing Components
Removing and Replacing the DVD I/O Board
105
Step 7. Using a torx #15 driver, remove the two torx screws holding the DVD I/O board cover plate to the
chassis and remove the cover plate.
Figure 4-43 Removing and Replacing the DVD I/O Board
Step 8. Unfasten the release clip attaching the DVD I/O board to the chassis. and remove the I/O board
from the chassis.
Step 9. Lift out the DVD I/O board and remove the midplane riser board connector cable and remove the
DVD I/O board from the chassis.
Cover
DVD I/O
board
To Next Page
Loading...
