HP Integrity rx4640 User's & Service Guide

Chapter 4
37
4 Removing and Replacing Components
This chapter describes the procedure for removing and replacing the different components in the HP Integrity
rx4640 server.
This chapter addresses the following topics:
• “Safety Information” on page 38
• “Service Tools Required” on page 38
• “Accessing a Rack Mounted Server” on page 38
• “Accessing a Pedestal Mounted Server” on page 40
• “Removing and Replacing the Front Bezel” on page 41
• “Removing and Replacing the Front and Top Covers” on page 42
• “Removing and Replacing the Memory Extender Board” on page 44
• “Removing and Replacing Server Memory DIMMs” on page 46
• “Removing and Replacing the Processor Extender Board” on page 52
• “Removing and Replacing a Processor” on page 55
• “Removing and Replacing Hot-Swap Chassis Fans” on page 63
• “Removing and Replacing the I/O Baseboard” on page 66
• “Removing and Replacing Hot-Plug PCI-X Cards” on page 71
• “Removing and Replacing OLX Dividers” on page 81
• “Removing and Replacing Core I/O Cards” on page 85
• “Removing and Replacing the Server Battery” on page 89
• “Removing and Replacing Hard Disk Drives” on page 90
• “Removing and Replacing the SCSI Backplane Board” on page 93
• “Removing and Replacing the Midplane Riser Board” on page 95
• “Removing and Replacing the Power Supplies” on page 98
• “Removing and Replacing the Power Distribution Board” on page 100
• “Removing and Replacing the DVD Drive” on page 102
• “Removing and Replacing the DVD I/O Board” on page 104
• “Removing and Replacing the Display Board” on page 107
• “Removing and Replacing the QuickFind Diagnostic Board” on page 109

HP Integrity rx4640 Specifications

General

Brand	HP
Model	Integrity rx4640
Category	Server
Language	English