Access Control Lists (ACLs) for the Series 3400cl and Series 6400cl Switches
Displaying ACL Data
Display an ACL Summary
This command lists the configured ACLs, regardless of whether they are
assigned to any interfaces.
Syntax: show access-list
List a summary table of the name, type, and application status
of all ACLs configured on the switch.
For example:
In this switch, ACLs 105 and “Red VLAN
Inbound” exist in the configuration but
are not applied to any interfaces s and
thus do not perform packet filtering.
Figure 10-21. Example of a Summary Table of Access lists
Term Meaning
Type Shows whether the listed ACL is
std (Standard; source-address only) or ext
(Extended; protocol, source, and destination data).
Appl Shows whether the listed ACL has been applied to an interface (
yes/no).
Name Shows the name or ID number assigned to each ACL configured in the switch.
Display the Content of All ACLs on the Switch
This command lists the configuration details for every ACL configured in the
running-config file, regardless of whether you have assigned any to filter traffic
on switch interfaces.
Syntax: show access-list config
List the configured syntax for all ACLs currently configured
on the switch.
10-59
To Next Page
Loading...
