HP ProCurve 6400cl Series - Displaying XRRP Data

Router Redundancy Using XRRP
Displaying XRRP Data
Displaying XRRP Data
To verify XRRP configuration and for XRRP status and statistics information
display, use the following CLI show xrrp commands at either the Manager level
or the global configuration level:
Syntax: show xrrp traps
This command displays the information on the configured XRRP traps.
HPswitch(config)# show xrrp traps
St atus and Counters - XRRP Traps Information
Tr ap Name | St atus
-- -------------------- + --------
st ate-change | En abled
ma ster-transition | Di sabled
au thentication-failure | Disabled
Figure 12-8. Example of Output for Show XRRP Traps
Syntax: show xrrp config [global | instance [< owner-router-num > < vlan-id >]]
This command displays XRRP configuration information. Invoked without
parameters it shows global and virtual routers configuration on the switch.
If the global keyword is specified, then the generic configuration information
is displayed.
HPswitch(config)# show xrrp config global
St atus and Counters - XRRP Global Configuration Information
X RRP Enabled : Yes
D omain Number : 2
R outer Number : 1
F ailback Delay : 11
Figure 12-9. Example of Output for Show XRRP Config Global
12-18