HP ProCurve 6400cl Series - Displaying OSPF Information

IP Routing Features
Configuring OSPF
Displaying OSPF Information
You can use CLI commands to display the following OSPF information:
OSPF Information Type Page
General Information
Area information
External link state information
Interface information
Link state information
Neighbor information
Route information
Virtual Neighbor information
Virtual Link information
11-53
11-55
11-56
11-57
11-60
11-62
11-68
11-65
11-66
Displaying General OSPF Configuration Information
To display general OSPF configuration information, enter show ip ospf general
at any CLI level:
HPswitch# show ip ospf general
OSPF General Status
OSPF protocol : enabled
Router ID : 10.0.8.36
RFC 1583 compatibility : compatible
Default import metric : 1
Default import metric type : external type 2
Area Border : yes
AS Border : yes
External LSA Count : 9
External LSA Checksum Sum : 408218
Originate New LSA Count : 24814
Receive New LSA Count : 14889
Figure 11-10.Example of Show IP OSPF General Output
11-53