Access Control Lists (ACLs) for the Series 3400cl and Series 6400cl Switches
Displaying ACL Data
Note Notice that you can use the output from this command for input to an offline
text file in which you can edit, add, or delete ACL commands. Refer to “Editing
ACLs and Creating an ACL Offline” on page 10-65.
This information also appears in the show running display. If you executed write
memory after configuring an ACL, it appears in the show config display.
For example, with two ACLs configured in the switch, you will see results
similar to the following:
Figure 10-22. Example of an ACL Configured Syntax Listing
Display the ACL Assignments for an Interface
This command briefly lists the identification and type(s) of ACLs currently
assigned to a particular interface (one or more ports and/or trunks) in the
running-config file. (The switch allows up to one, inbound ACL assignment
per interface.)
Syntax:
show access-list ports < interface >
List the ACLs assigned to interfaces in the running config file.
Note This information also appears in the show running display. If you executed write
memory after configuring an ACL, it appears in the show config display.
10-60
To Next Page
Loading...
